Western Digital Ultrastar Serv60+8 User Manual page 173

User Guide
b)
Caution:
and that the detent has engaged. This is to prevent potential damage due to improper mating
of the rails.
Position one individual on each side of the enclosure to perform a team lift and have the third individual
standing at the protruding rack rails to guide the chassis to mate with rack rails.
c) Team-lift the enclosure until the inner rails that are attached to the chassis align with the extended
mid-rails attached to the rack, and guide the inner rails on the chassis to mate with the rack rails.
d) Once the rails are mated properly, slide the enclosure into the rack until it is stopped by the safety
catch on the rails. Push the release lever on the safety latch located on the side of each of the rails
and push the enclosure the rest of the way into the rack.
Figure 210: Safety Latch Release
e) As the chassis is slid into the rack, position one installer at the rear of the rack to ensure that the pegs
on the sides of the cover will slide correctly into the rear cover alignment brackets on both sides of
the rack. If the chassis does not install smoothly or snags, check that the rear cover alignment brackets
are not interfering with the chassis sidewalls, and try again.
17. Now that the chassis is installed, test the installation by sliding the enclosure in and out of the rack a
minimum of three times. If the enclosure binds, catches, or displays any incorrect motion or behavior
retry the installation.
Note: Adjustments of the vertical rack rails may be required to fix any issues that may
occur.
18. Install the CMA.
a) Orient the CMA so that the elbow is on the left hand side.
Make sure that the bearing plate on the inside of the mid-rails are fully forward
173
4 Part Replacement
4.10 M.2 Replacement