Western Digital Ultrastar Serv60+8 User Manual page 179

User Guide
2. Unlatch all of the connectors that attach the CMA to the enclosure and the rail by locating the latch release
button and pressing it from either side of the latch. There are three total connections that need to be
removed, one at the elbow and two at the opposite end.
Figure 216: Unlatching a CMA Connector
3. Grasp both handles at the front of the enclosure and pull with even pressure to extend the chassis out
of the rack until it is stopped by the safety latches. The safety latches will prevent the enclosure from
coming out of the rack completely and the cover will remain in the rack attached to the rear alignment
brackets.
Figure 217: Chassis Handle Operation
4. Remove all of the drives from the chassis before uninstalling the chassis. Be prepared to label the drives
as they are removed so they can be reinstalled in the same location in the new chassis.
5. Follow these steps to remove a Drive Assembly.
a) Find the latch release mechanism on the Drive Assembly being removed.
179
4 Part Replacement
4.11 Add-in Card Replacement