Western Digital Ultrastar Serv60+8 User Manual page 261

User Guide
c) Slide the inner rail toward the rear of the chassis to lock it in place. There will be an audible click and
the mounting pegs will cover the front part of the keyhole.
Figure 341: Slide Inner Rail
d)
Caution:
special Low-Profile M4 x 3.2mm Philips screws provided in the accessory kit with the CMA.
These screws should be tightened to .90-1.12 Nm / 8-10 in-lbf using a # 2 Philips Screwdriver.
These screws are specially designed for this purpose. Using unapproved screws could cause
damage to the slides inside the rail.
Install the three special low-profile M4 x 3.2mm Philips screws provided to secure the inner rail to the
chassis.
e) Follow these steps for the second inner rail on the opposite side of the enclosure.
Click
When installing the inner rail onto the chassis, make sure to only use the
261
4 Part Replacement
4.14 Chassis Replacement
Click