Western Digital Ultrastar Serv60+8 User Manual page 339

User Guide
1. Grasp both handles at the front of the enclosure and pull with even pressure to extend the chassis out of
the rack until it is stopped by the safety latches. The safety latches will prevent the enclosure from coming
out of the rack completely and the cover will remain in the rack attached to the rear alignment brackets.
Figure 446: Chassis Handle Operation
2. Locate the area that the new drives will be installed into. When adding SSDs, the drives slots may already
contain a drive. The drive will have to be removed and relocated before installing the HDD.
3. Follow the requirements for partial populations listed in
4. Install the Drive Assembly.
a) Ensure that the enclosure has been pulled out of the rack until the rail latches engage.
b) Find the LED pointer on the top of the drive carrier. This pointer should point toward the front of the unit
as shown in the following image.
Figure 447: LED Pointer Orientation
Partial Population Configurations
FRONT
339
5 System Management
5.4 Partially Populated Enclosures
REAR
on page 335.