Western Digital Ultrastar Serv60+8 User Manual page 204

User Guide
if there is proper lift/support equipment rated to support the full weight of the enclosure, 95.25 kg / 210
lbs. , these steps can be skipped. If not, please follow these drive removal instructions to remove all of
the drives and reduce the weight. Never try to support the weight of the full system by hand. Doing
so could cause damage to the system or serious bodily harm.
6. Grasp both handles at the front of the enclosure and pull with even pressure to extend the chassis out
of the rack until it is stopped by the safety latches. The safety latches will prevent the enclosure from
coming out of the rack completely and the cover will remain in the rack attached to the rear alignment
brackets.
Figure 254: Chassis Handle Operation
7. Follow these steps to remove a Drive Assembly.
a) Find the latch release mechanism on the Drive Assembly being removed.
b) Insert a finger and a thumb into the latch release and pinch to unlatch the Drive Assembly.
Figure 255: Unlatch Drive Carrier (IOM Not Shown)
204
4 Part Replacement
4.13 Rails Replacement