Western Digital Ultrastar Serv60+8 User Manual page 248

User Guide
c) Firmly press the DIMM into the slot until the ejector tabs snap into place over the notches on either
side of the DIMM.
Figure 320: DIMM Notches
34. Install the CPU and Heat Sink module.
a) Locate the socket alignment pin on the baseboard and the alignment hole on the Heat Sink.
b) Carefully place the CPU and Heat Sink module in position on the socket alignment pins.
Figure 321: Heat Sink Alignment Pins
c) The Heat Sink must be installed by tightening the Torx T30 screws in a specific order. Use the following
diagram to determine the specific order.
248
4 Part Replacement
4.14 Chassis Replacement