Speed; Unicast-Suppression - 3Com 5500G-EI Command Reference Manual

speed

unicast-suppression

Syntax
For a 100 Mbps Ethernet port, the parameters for this command are as follows:
speed { 10 | 100 | auto }
For a 1000 Mbps Ethernet port, the parameters for this command are as follows:
speed { 10 | 100 | 1000 | auto }
For a 10000 Mbps Ethernet port, the parameters for this command are as follows:
speed { 10 | 100 | 1000 | 10000 | auto }
The undo form of this command is:
undo speed
View
Ethernet Port View
Parameter
Enter to set the port speed to 10 Mbps.
10:
Enter to set the port speed to 100 Mbps.
100:
: Enter to set the port speed to 1000 Mbps.
1000
:Enter to set the port speed to 10000 Mbps.
10000
Enter to set the port speed to auto-negotiation.
auto:
Description
Use the command to configure the port speed. Use the
speed
command to restore the default speed. By default, the speed is
Related command:
duplex
Example
To configure the port speed of port Ethernet1/0/1 to 10 Mbps, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]speed 1000
Syntax
unicast-suppression {
undo unicast-suppression
View
Ethernet Port View
Ethernet Port Configuration Commands
.
ratio | pps pps }
67
undo speed
.
auto