3Com 5500G-EI Command Reference Manual page 150

150 C 6: U R
HAPTER SING
P C
OUTING ROTOCOL OMMANDS
Enter either the IP subnet mask (in x.x.x.x format), or the subnet mask length
mask
(in the range 0 to 32). Optional.
Enter to display an address route that matches the destination IP
longer-match
address in natural mask range . Optional.
Enter to display verbose information about both active and inactive
verbose
routes. Without this parameter, this command only displays a summary of active
routes. Optional.
Description
Use the
display ip routing-table ip_address
information for a specific IP address, and you can also choose the type of
information to display. If the destination address,
corresponding route in natural mask range, this command will display all subnet
routes or only the route best matching the destination address,
displayed. And only the active matching route is displayed.
Use the
display ip routing-table
route that matches the specified IP destination address and subnet mask.
Use the
display ip routing-table
display all destination address routes that match destination IP addresses in natural
mask range.
Use the
display ip routing-table
verbose information about both active and inactive routes.
Example
There is corresponding route in natural mask range. Display the summary.
<SW5500>display ip routing-table 169.0.0.0
Routing Tables:
Summary count:1
Destination/Mask
169.0.0.0/16
There are corresponding routes in the natural mask range. Display the detailed
information.
<SW5500>display ip routing-table 169.0.0.0 verbose
Routing Tables:
Generate Default: no
+ = Active Route, - = Last Active, # = Both* = Next hop in use
Summary count:2
**Destination: 169.0.0.0
Protocol: #Static
*NextHop: 2.1.1.1
Vlinkindex: 0
State: <Int ActiveU Static Unicast>
Age: 3:47
**Destination: 169.0.0.0
Protocol: #Static
*NextHop: 2.1.1.1
Vlinkindex: 0
State: <Int ActiveU Static Unicast>
ip_address mask
ip_address
ip_address
Proto Pre
Static 60
Mask: 255.0.0.0
Preference: 60
Interface: 2.1.1.1(LoopBack1)
Cost: 0/0
Mask: 255.254.0.0
Preference: 60
Interface: 2.1.1.1(LoopBack1)
command to view routing
, has a
ip_address
ip_address
command to display the
longer-match
command to display
verbose
Cost Nexthop Interface
0 2.1.1.1 LoopBack1
, is
command to