Retry - 3Com 5500G-EI Command Reference Manual

386 C 11: U
HAPTER SING

retry

AAA RADIUS C
AND OMMANDS
and ">". The @ character can only be used once in one username. The pure
username (the part before @, namely the user ID) cannot exceed 24 characters.
Description
Use the
reset stop-accounting-buffer
accounting requests, which are saved in the buffer and have not been responded.
By default, after transmitting the stopping accounting requests, if there is no
response from the RADIUS server, the Switch will save the packet in the buffer and
retransmit it for several times, which is set through the
realtime-accounting
This command is used to delete the stopping accounting requests from the Switch
buffer. You can select to delete the packets transmitted to a specified RADIUS
server, or according to the session-id or username, or delete the packets
transmitted during the specified time-range.
Related commands:
stop-accounting
Example
To delete the stopping accounting requests saved in the system buffer by the user,
user0001@marlboro.net, enter the following:
[SW5500]reset stop-accounting-buffer user-name user0001@marlboro.net
To delete the stopping accounting requests saved in the system buffer since 0:0:0
to 23:59:59 on August 31, 2002, enter the following:
[SW5500]reset stop-accounting-buffer time-range 0:0:0-2002/08/31
23:59:59-2002/08/31
Syntax
retry-times
retry
undo retry
View
RADIUS Scheme View
Parameter
Specifies the maximum times of retransmission, ranging from 1 to
retry-times
:
20. By default, the value is 3.
Description
Use the command to configure the RADIUS request retransmission times.
retry
Use the
undo retry
Because RADIUS protocol uses UDP packets to carry the data, its communication
process is not reliable. If the RADIUS server has not responded NAS until timeout,
NAS has to retransmit RADIUS request packet. If it transmits more than the
specified retry-time, NAS considers that the communication with the current
command.
stop-accounting-buffer enable
,
display stop-accounting-buffer
command to restore the
command to reset the stopping
retry
,
retry
.
to default value.
retry-times