Snmp-Agent Trap Enable - 3Com 5500G-EI Command Reference Manual

486 C 12: U
HAPTER SING

snmp-agent trap enable

S M C
YSTEM ANAGEMENT OMMANDS
Use the
undo snmp-agent target-host
configured to receive SNMP notification.
You must enter the
snmp-agent target-host
enables the device to transmit Trap packets. To send Trap messages, at least one
snmp-agent target-host
Example
To enable Trap messages to be sent to
enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]snmp-agent trap enable
[SW5500]snmp-agent target-host trap address udp-domain 2.2.2.2
params securityname guest
[SW5500]
To enable Trap messages to be sent to
, enter the following:
public
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]snmp-agent trap enable
[SW5500]snmp-agent target-host trap address udp-domain 2.2.2.2
params securityname public
Syntax
snmp-agent trap enable [ configuration | flash | ospf [
ospf-trap-list
[
| linkup | warmstart ]* | system ]
undo snmp-agent trap enable [ bgp [ backwardtransition ] [
established ] | configuration | flash | ospf [
ospf-trap-list
linkup | warmstart ]* | system ]
View
System view
Parameter
configuration:
Configure to send SNMP flash Trap packets.
flash:
process-id
ospf [
packets.
process-id
ospf-trap-list
standard [ authentication | coldstart | linkdown | linkup | warmstart
: Configure to send standard Trap messages.
]*
authentication
when authentication fails.
snmp-agent trap enable
command. The
command should be configured.
2.2.2.2
2.2.2.2
] | standard [ authentication | coldstart | linkdown
] | standard [ authentication | coldstart | linkdown |
Configure to send SNMP configuratin Trap packets.
ospf-trap-list
] [
is the ID of the OSPF process, ranging from 1 to 65535.
is the list of OSPF trap information.
: Configure to send SNMP authentication Trap messages
command to cancel the host currently
command before you enter the
snmp-agent trap enable
with a community name of
with a community name of
process-id
: Configure to send the OSPF trap
]
command
,
guest
process-id
]
] [