Qos Configuration Commands List; Display Mirror - 3Com 5500G-EI Command Reference Manual

290 C 8: U
HAPTER SING
QoS Configuration
Commands List

display mirror

Q S/ACL C
O OMMANDS
end-time end-date
to
start-time start-date
certain period, notated as hh:mm MM/DD/YYYY.
If the above two parameters are not configured, it means there is no restriction to
time-range.
Description
Use the
time-range
Use the
undo time-range
If you input the parameter when using the
system will cancel the corresponding content of the parameters in the time range.
Example
Configure a time range to take effect at 00:00 on January 1, 2000 with no end
date specified.
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]time-range test from 0:0 1-1-2000
This section describes how to use the Quality of Service (QoS) configuration
commands on your Switch 5500G-EI.
Syntax
display mirror
View
Any view
Parameter
None
Description
Use the
display mirror
including monitored ports, monitor port and monitor direction, and so on.
Related commands:
Example
To display the port mirroring configuration, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500] display mirror
Monitor-port:
GigabitEthernet1/0/1
Mirroring-port:
GigabitEthernet1/0/2
:: The end date of a special time-range, together with
means this special time-range is effective during a
command to configure a time range.
command to delete a time range.
command to view port mirroring configuration,
,
mirroring-port monitor-port
both
command, the
undo time-range
.