Display Rip Interface - 3Com 5500G-EI Command Reference Manual

display rip interface

Example
To display the current running state and configuration information of RIP, enter the
following:
<SW5500>display rip
RIP is running
public net VPN-Instance
Checkzero is on
Summary is on
Traffic-share-across-interface is off
Period update timer : 30
Timeout timer : 180
Garbage-collection timer : 120
No peer router
Network :
202.38.168.0
Table 22 Output Description of the
Field
RIP is running
Checkzero is on
Default cost:1
Summary is on
Preference: 100
Period update timer : 30
Timeout timer : 180
Garbage-collection timer : 120
No peer router
Network: 202.38.168.0
Syntax
display rip interface
View
All views
Parameter
None
Description
Use the
display rip interface
Example
To display rip interface information, enter the following:
<SW5500>display rip interface
RIP Interface: public net
Address Interface
1.0.0.1 Vlan-inteface1002
RIP Configuration Commands
Default cost : 1
Preference : 100
Command
display rip
Description
RIP is active
Zero field checking is enabled
The default route cost is 1
Routes are summarized automatically
The preference of RIP is 100
The three RIP timers
No destination address of a transmission is specified
RIP enabled on network segment 202.38.168.0
command to view RIP interface information.
Ver MetrIn/Out Input Output
0/1 on
161
Split-horizon
on on