Authentication-Mode - 3Com 5500G-EI Command Reference Manual

authentication-mode

Enter the IP subnet mask.
mask
Enter this parameter if you do not want to advertise routes
not-advertise
matching the specified IP address and mask.
Enter a tag value, which is mainly used to control advertisement of
value
tag
routes via route-policy. This value can be in the range 0 to 4294967295. The
default is 1.
Description
Use the
asbr-summary
OSPF.
Use the
undo asbr-summary
After the summarization of imported routes is configured, if the local router is an
autonomous system border router (ASBR), this command summarizes the
imported Type-5 LSAs in the summary address range. When NSSA is configured,
this command will also summarize the imported Type-7 LSAs in the summary
address range.
If the local router acts as both an ABR and an ASBR in the NSSA, this command
summarizes Type-5 LSAs translated from Type-7 LSAs. If the router is not the ASBR
in the NSSA, the summarization is disabled.
Related commands:
display
Example
To summarize the OSPF imported routes, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]router id 1.1.1.1
[SW5500]ospf
[SW5500-ospf]asbr-summary 10.2.0.0 255.255.0.0 not-advertise
Syntax
authentication-mode { simple | md5 }
undo authentication-mode
View
OSPF Area View
Parameters
Enter to configure simple text authentication mode.
simple
Enter to configure MD5 cipher text authentication mode.
md5
Description
Use the
authentication-mode
specified authentication mode.
command to configure a summary of imported routes for
command to cancel the summary. This is the default.
ospf asbr-summary
command to configure an OSPF area to use a
OSPF Configuration Commands
.
179