3Com 5500G-EI Command Reference Manual page 38

38 C 1: U S
HAPTER SING YSTEM
A C
CCESS OMMANDS
directory
ftp-directory
character string of up to 64 characters.
: Specifies user type to lan-access, which mainly refers to Ethernet
lan-access
accessing users, 802.1x supplicants for example.
: Authorizes the user to use the terminal service (login from the Console
terminal
port).
Description
Use the command
service-type
access after login. Use the command
level of command (level 1).
Commands are classified into four levels, as follows:
0 - Visit level. Users at this level have access to network diagnosis tools (such as
■
ping and tracert), and the Telnet commands. A user at this level cannot save
the configuration file.
1 - Monitoring level. Users at this level can perform system maintenance,
■
service fault diagnosis, and so on. A user at this level cannot save the
configuration file.
2 - System level. Users at this level can perform service configuration
■
operations, including routing, and can enter commands that affect each
network layer. Configuration level commands are used to provide direct
network service to the user.
3 - Management level. Users at this level can perform basic system operations,
■
and can use file system commands, FTP commands, TFTP commands, XModem
downloading commands, user management commands and level setting
commands.
Example
To allow a user to configure commands a level 0 after login, enter the
zbr
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]local-user zbr
[SW5500-luser-zbr]service-type telnet level 0
To activate these settings, quit the system and login with the username
only the commands at level 0 are listed on the terminal.
[SW5500]quit
<SW5500>?
User view commands:
language-mode
ping
quit
super
telnet
tracert
: Specifies the directory of ftp users, directory is a
to configure which level of command a user can
undo service-type
Specify the language environment
Ping function
Exit from current command view
Set the current user priority level
Establish one TELNET connection
Trace route function
to restore the default
Now
zbr.