Display Ip Routing-Table Protocol - 3Com 5500G-EI Command Reference Manual

display ip routing-table
protocol
Vlinkindex: 0
State: <NoAdvise Int ActiveU Retain Gateway Unicast>
Age: 3:23:44
For detailed information of the output information, refer to
Syntax

display ip routing-table protocol

View
All views
Parameters
Enter one of the following:
protocol
Displays the direct connection route information
■ direct
Displays the static route information.
■ static
Displays OSPF route information.
■ ospf
Displays OSPF ASE route information.
■ ospf-ase
Displays OSPF NSSA route information.
■ ospf-nssa
Displays RIP route information.
■
rip
Enter to display inactive route information. Without this parameter, the
inactive
command displays both active and inactive route information. Optional.
Enter to display verbose route information. Without this parameter, the
verbose
command displays the route summary. Optional.
Description
Use the
display ip routing-table protocol
information for a specified protocol.
Example
To display a summary of all direct connection routes, enter the following:
<SW5500>display ip routing-table protocol direct
The information displays in the following format:
DIRECT Routing tables:
Summary count: 4
DIRECT Routing tables status:<active>:
Summary count: 3
Destination/Mask
20.1.1.1/32
127.0.0.0/8
127.0.0.1/32
DIRECT Routing tables status:<inactive>:
Summary count: 1
Destination/Mask
210.0.0.1/32
Cost: 0/0 Tag: 0
protocol
Protocol Pre Cost Nexthop
DIRECT 0 0
DIRECT 0 0
DIRECT 0 0
Protocol Pre Cost Nexthop
DIRECT 0 0
Routing Table Display Commands
Table 18.
[ inactive | verbose ]
command to view the route
Interface
127.0.0.1 InLoopBack0
127.0.0.1 InLoopBack0
127.0.0.1 InLoopBack0
Interface
127.0.0.1 InLoopBack0
153