Display Lacp System-Id - 3Com 5500G-EI Command Reference Manual

display lacp system-id

Description
Use the
display link-aggregation interface
aggregation information at a designated port, including aggregation group ID for
the port, port priority, operation key, LACP state flag, partner information (system
ID, port number, port priority, operation key, LACP state flag, LACP packet
statistics).
Note that unlike a dynamic aggregation, a manual aggregation has no protocol to
get the remote peer information of the partner. Therefore, every item for the
remote peer is 0. This does not indicate the actual state of the remote peer.
Example
To display detailed link aggregation information of a link aggregation member
port, enter the following:
<SW5500>display link-aggregation interface Gigabitethernet4/0/1
If the aggregation has been created manually, the display will be similar to the
following:
GigabitEthernet4/0/1:
Attached AggID: 1
Local:
Port-Priority: 32768, Oper key: 1, Flag: 0x00
Remote:
System ID: 0x0, 0000-0000-0000
Port Number: 0, Port-Priority: 0, Oper-key: 0, Flag: 0x00
If the aggregation is static or dynamic, the display will be similar to the following:
<SW5500>display link-aggregation interface Gigabitethernet4/0/1
GigabitEthernet1/0/1:
Attached AggID: 20
Local:
Port-Priority: 32768, Oper key: 2, Flag: 0x3d
Remote:
System ID: 0x8000, 000e-84a6-fb00
Port Number: 2, Port-Priority: 32768 , Oper-key: 10, Flag: 0x3d
Received LACP Packets: 8 packet(s), Illegal: 0 packet(s)
Sent LACP Packets: 9 packet(s)
Related command:
display link-aggregation verbose
Syntax
display lacp system-id
View
Any view
Parameter
None
Ethernet Port Link Aggregation Commands
command to view detailed link
.
73