Display Mac-Address Aging-Time - 3Com 5500G-EI Command Reference Manual

432 C 12: U
HAPTER SING
display mac-address
aging-time
S M C
YSTEM ANAGEMENT OMMANDS
For details about the
parameters, refer to the Port Configuration in this manual.
: the display information will only contain the number of MAC addresses in
count
the MAC address table if the user enters this parameter when using this
command.
Description
Use the
display mac-address
information.
When managing the Layer-2 addresses of the switch, the administrator can
perform this command to view such information as the Layer-2 address table,
address status (static or dynamic), Ethernet port of the MAC address, VLAN of the
address, and system address aging time.
For the related commands, see
Example
Show the information of the entry with MAC address at 00e0-fc01-0101
[SW5500]display mac-address 00e0-fc01-0101
MAC ADDR
00e0-fc01-0101
Syntax

display mac-address aging-time

View
All views
Parameter
None
Description
Use the
display mac-address aging-time
of the dynamic entry in the MAC address table.
For the related commands, see
.
mac-address
Examples
Display the aging time of the dynamic entry in the MAC address table.
[SW5500]display mac-address aging-time
mac-address aging-time: 300s
The above information indicates that the aging time of the dynamic entry in the
MAC address is 300s.
[sw5500] display mac-address aging-time
mac-address aging-time: no-aging
,
interface-type interface-num
command to display MAC address table
mac-address
VLAN ID STATE
1 Learned
mac-address
and
interface-name
, .
mac-address timer
PORT INDEX AGING TIME(s)
GigabitEthernet1/0/1
command to display the aging time
, ,
mac-address timer
300
display