Snmp-Agent Trap Life - 3Com 5500G-EI Command Reference Manual

snmp-agent trap life

: Configure to send SNMP cold start Trap messages when switch is
coldstart
rebooted.
: Configure to send SNMP link down Trap messages when switch port
linkdown
turns down.
: Configure to send SNMP link up Trap messages when switch port
linkup
turns up.
: Configure to send SNMP warm start Trap messages when snmp is
warmstart
re-enabled.
Configure to send SysMib trap messages.
system:
Description
Use the
snmp-agent trap enable
message. Use the
undo snmp-agent trap enable
message sending.
By default, Trap message sending is disabled.
The
snmp-agent trap enable
command should be used at the same time. The
command specifies which hosts can receive Trap message. To send Trap messages,
at least one
snmp-agent target-host
Example
Enable to send the trap packet of SNMP authentication failure to
community name is
guest
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]snmp-agent trap enable standard authentication
[SW5500]snmp-agent target-host trap address udp-domain 10.1.1.1
param securityname guest
Syntax
snmp-agent trap life
undo snmp-agent trap life
View
System view
Parameter
Specify the timeouts, ranging from 1 to 2592000 seconds. By default,
seconds:
the timeout interval is 120 seconds.
Description
Use the
snmp-agent trap life
the
undo snmp-agent trap life
The set timeout of Trap packet is represented by
, this Trap packet will be discarded.
seconds
SNMP Configuration Commands
command to enable the device to send Trap
command and the
command should be configured.
.
seconds
command to set the timeout of Trap packets. Use
command to restore the default value.
command to disable Trap
snmp-agent target-host
snmp-agent target-host
10.1.1.1
. If time exceeds
seconds
487
. The