Filter-Policy Export - 3Com 5500G-EI Command Reference Manual

filter-policy export

Example
Display the information of Route-policy named as policy1.
<SW5500>display route-policy policy1
Route-policy : policy1
Permit 10 : if-match (prefixlist) p1
apply cost 100
matched : 0
Table 40 Output Description of the
Field Description
Route-policy Name of ip-prefix
Permit 10 Information of the route-policy with mode as permit and node as 10:
if-match (prefixlist) p1 — The configured if-match clause
■
apply cost 100 — Apply routing cost 100 to the routes matching the
■
conditions defined by if-match clause
matched — Number of routes matchng the conditions set by if-match
■
clause
denied — Number of routes not matching the conditions set by if-match
■
clause
Syntax
acl_number
filter-policy {
protocol ]
undo filter-policy {
protocol
[ ]
View
Routing Protocol view
Parameter
Enter the number of the access control list used for matching the
acl_number
destination address field of the routing information.
Enter the address prefix list used for matching the routing
ip_prefix_name
information destination address field.
Enter the routing information of which kind of route protocol to be
protocol
filtered.
Description
Use the
filter-policy export
conditions of the routing information advertised by a certain type of routing
protocols.
Use the
undo filter-policy export
set.
By default, the advertised routing information is not filtered.
IP Routing Policy Configuration Commands
denied : 0
display route-policy
ip_prefix_name
| ip-prefix
acl_number | ip-prefix
command to configure to set the filtering
command to cancel the filtering conditions
Command
} export [
ip_prefix_name } export
223