Configuration Commands; Display Dot1X - 3Com 5500G-EI Command Reference Manual

802.1x Configuration
Commands

display dot1x

This section describes how to use the 802.1x configuration commands on your
Switch 5500G-EI.
Syntax
display dot1x [ sessions | statistics [ interface
View
All views
Parameter
Displays the 802.1x information on the specified interface.
interface:
Displays the session connection information of 802.1x.
sessions:
Displays the relevant statistics information of 802.1x.
statistics:
Ethernet interface list including several Ethernet interfaces,
interface-list
:
expressed in the format
interface-num ] } & < 1-10 >
interface in the format
, where
interface-name
}
specifies the interface number and
interface-num
interface name. For the respective meanings and value ranges, read the Parameter
of the Port Command Manual section.
Description
Use the
display dot1x
including configuration information, running state (session connection
information) and relevant statistics information.
By default, all the relevant 802.1x information about each interface will be
displayed.
This command can be used to display the following information on the specified
interface: 802.1x configuration, state or statistics. If no port is specified when
executing this command, the system will display all 802.1x related information.
For example, 802.1x configuration of all ports, 802.1x session connection
information, and 802.1x data statistical information. The output information of
this command can help the user to verify the current 802.1x configurations so as
to troubleshoot 802.1x.
Related commands:
reset dot1x statistics
,
max-user dot1x port-control
Example
Display the configuration information of 802.1x.
<SW5500>display dot1x
Equipment 802.1X protocol is enabled
DHCP-launch is disabled
EAP-relay is enabled
Proxy trap checker is disabled
Proxy logoff checker is disabled
interface-list
= {
. interface-num specifies a single Ethernet
interface-num interface-type interface-num
= {
interface-type
command to view the relevant information of 802.1x,
,
dot1x port-method
802.1x Configuration Commands
interface-list
interface-num
[ to
specifies the interface type,
interface-name
, ,
dot1x dot1x retry
,
dot1x timer
343
]]
|
specifies the
,
dot1x
.