Stp Edged-Port - 3Com 5500G-EI Command Reference Manual

stp pathcost-standard
stp point-to-point
This command can be used for specifying the current Ethernet Switch to run the
Spanning Tree in RSTP mode or in STP compatible mode.
Related commands:
stp
Example
To set Spanning Tree to work in STP compatible mode, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]stp mode stp
Syntax
stp pathcost-standard { dot1d-1998 | dot1t }
undo stp pathcost-standard
View
System view
Parameter
The Switch calculates the default Path Cost of a port by the IEEE
dot1d-1998:
802.1D-1998 standard.
The Switch calculates the default Path Cost of a port by the IEEE 802.1t
dot1t:
standard.
Description
Use the
stp pathcost-standard
the Switch in calculating the default Path Cost.
Use the
undo stp pathcost-standard
the standard.
By default, the Switch calculates the default Path Cost of a port by the IEEE 802.1t
standard.
Example
To configure the Switch to calculate the default Path Cost of a port by the IEEE
802.1D-1998 standard, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]stp pathcost-standard dot1d-1998
To configure the Switch to calculate the default Path Cost of a port by the IEEE
802.1t standard, enter the following:
[SW5500]stp pathcost-standard dot1t
Syntax
stp point-to-point { force-true | force-false | auto }
undo stp point-to-point
, .
stp mcheck
command to specify the standard to be used by
command to restore the default choice of
RSTP Configuration Commands 331