The Indicator Bar - Agilent Technologies N4413A User Manual

User Interface
The Main Screen
4 The system displays messages at the bottom of the screen in the Message Window.
5 If Measure Count is enabled, it shows the number of measurements made. See
"Utility > Measurement Counter Visible" on page
6 Measure starts the measurement sequence. See
page 47.
7 Continuous Sweep performs the next measurement with continuous sweeps.
Click the STOP button to stop continuous measurements.
NOTE: If Continuous Sweep is enabled, Measure Count does not increment.
8 Use the DEVICE: and SN: boxes to the right to enter information about the device
under test. This information is saved with the DUT data set and appears in printouts
and exported data files.
9 The Indicator Bar shows the measurement settings. See
page 12.
10 Port Impedance, as defined through the setup, is shown in this area unless all ports
are set to 50Ω.

The Indicator Bar

The Indicator Bar buttons show measurements settings.
• Green buttons show settings that will affect future measurements.
• Blue buttons show settings applied to the current data.
De-embedding Indicators
De-embedding or reference plane rotation has been activated in Setup.
The data has been modified by de-embedding or reference plane rotation.
See "Setup > Modify Rotations..." on page
12
151.
"How to Make Measurements" on
119.
"The Indicator Bar" on
Chapter 2