Agilent Technologies N4413A User Manual page 204

Instrument Information
Front and Rear Panels
N4421A Rear Panel
ID Rear Panel
Number Feature
1 REF 2 R OUT
2 REF 2 R IN
3 BUS
ADDRESS
4 REF 1 R IN
5 REF 1 R OUT
6 Power Cord
Connector
7 IEEE-488
8 PORT 2 BIAS
9 PORT 2
FUSE
194
Feature Description
2.4 mm (f) connector, used as an output reference signal
2.4 mm (f) connector, used as an input reference signal.
Switch that is used to set the GPIB address. Refer to
the GPIB Addresses" on page 38
2.4 mm (f) connector, used as an input reference signal
2.4 mm (f) connector, used as an output reference signal
Connector, 100-120 Vac or 220-250Vac input and
Fuse, T 2.5 A 250 V (Agilent part number 2110-0681)
24-pin IEEE-488/PCB (f) connector. The GPIB is the
communication bus with the PC and the network analyzer.
BNC (f) connector. The bias port is used to supply a dc voltage
to an active DUT, such as an amplifier or a transistor.
Bias Fuse, 0.5 A, 250 V (Agilent part number 2110-0012)
for further information.
Chapter 7
"To Set