Calibrate Menu; Calibrate > Create Cal Subset - Agilent Technologies N4413A User Manual

Calibrate Menu

The following is a list of the Calibrate menu selections and their locations:
• "Calibrate > Create Cal Subset..." on page 133
• "Calibrate > Remove Cal Subset" on page 135
• "Calibrate > Standard Calibration..." on page 135
• "Calibrate > Electronic Calibration..." on page 135
• "Calibrate > Delete Current Cal" on page 135
Calibrate > Create Cal Subset...
Pull down Calibrate > Create Cal Subset... to create a subset of an existing calibration
data set. Using a calibration subset can speed up measurement sweeps when you only need to
measure a small span within the span of calibration. Creating the calibration subset allows
you to change the frequency range while retaining the complete calibration settings.
If a calibration has not been performed or an existing calibration file is not opened, this menu
selection is unavailable. The Create Calibration Subset screen is displayed when this menu
item is selected.
Chapter 5
Menu Reference
Calibrate Menu
133