Utility Menu
The following is a list of the Utility menu selections and their locations:
•
"Utility > Manual Test-Set Control..." on page 147
•
"Utility > Characterize Adapter..." on page 150
•
"Utility > Measurement Counter Visible" on page 151
•
"Utility > Reset Measurement Counter" on page 151
•
"Utility > Diagnostics" on page 151
Utility > Manual Test-Set Control...
Pull down Utility > Manual Test-Set Control... to open the Manual Test Set dialog box. The
two dialog box tabs, Switch Positions and Attenuator, are helpful when troubleshooting a
problem with your setup. Use this dialog box to configure the test set and vector network
analyzer (VNA) for the desired stimulus/response setting:
• Stimulus can be directed to a test-port so that the incident power level that will be
presented to the DUT can be measured.
• System checks can be performed on the various RF paths in the test-set.
• Scalar corrections can be implemented in the VNA using trace memory to aid the tuning of
a DUT.
Chapter 5
Menu Reference
Utility Menu
147