Agilent Technologies N4413A User Manual page 137

Menu Reference
Setup Menu
Select Display analyzer settings and de-embed information when Measure is
selected to have the system show this information prior to a measurement. This allows you
to confirm that the measurement settings are correct before beginning a measurement.
Select Blank old data during measurement to have the system stop showing any old
measurements on display while a new measurement is being made.
Select Beep when measurement is complete to have the system give you an audible
prompt on completion of a measurement.
Select Show warning before uncalibrated measurements to display a warning if the
system has not been calibrated when a measurement is attempted.
Verify before clearing measurement data is not implemented.
Click the Print tab to display the print preference options.
Select Carry forward last print annotation field to new prints to have the system
remember any notes you entered in the Print Annotation dialog box from one measurement to
the next. These notes can be changed at any time prior to printing.
Select Clear annotation when new measurement is made to have the system clear the
note field in the Print Annotation dialog box for each new measurement.
Select Print background color to use the gray background around the measurement
displays. You may want to make prints without the gray background if the print will be faxed,
since the background can slow down faxing.
Click Print image to disk file to have the system default to save the images, rather than
printing them.
Click Add measurement timestamp to annotation to have the system include the date
and time of the measurement to the printed copies.
Chapter 5 127