Agilent Technologies N4413A User Manual page 133

Click LOAD ALL to load all the display configurations associated with a configuration file
without selecting individual display configurations.
Click SAVE ALL to save all the currently loaded display configurations.
Click Restore Defaults to undo any changes that have been made since the beginning of the
session to primary and user-defined displays.
Click CLOSE to close the Display Configuration dialog box.
The normal sequence of events in using display configuration is:
1. Define a display configuration through using the system.
2. Pull down Setup > Display Configuration... and click Capture Config.
3. Identify the configuration by entering a name under Config Identifier.
4. Define and capture up to six display configurations per configuration file.
5. In the Display Configuration dialog box, click SAVE ALL to save the configurations.
6. In subsequent sessions click LOAD ALL to load an entire configuration file or click Load
Config to load an individual configuration into a slot in the Display Configuration dialog
box.
The format of the .mpc file has changed from older versions of the software.
NOTE
However, you can load configuration files generated by older versions into the
current version of the software.
To recall a display configuration generated by a previous version of the software, follow these
steps:
1. Click the LOAD ALL button.
2. In the Open dialog box, select an old configuration file and click Open.
3. Click Set Display. The system displays an Error message. Follow the instructions in the
message.
Chapter 5
Menu Reference
Setup Menu
123