Calibrate > Remove Cal Subset; Calibrate > Standard Calibration; Calibrate > Electronic Calibration; Calibrate > Delete Current Cal - Agilent Technologies N4413A User Manual

Menu Reference
Calibrate Menu
Click Save Cal Subset to save the new calibration subset. In the Save As dialog box, enter
the file name and click Save.
Click Make Subset Cal the Active Cal to redefine the current subset as full calibration.
Click Restore Full-Sweep Calibration to restore the full-sweep calibration set.
At any time click CLOSE to close the dialog box.
Calibrate > Remove Cal Subset
Pull down Calibrate > Remove Cal Subset to delete the current subset of the existing
calibration data set.
Calibrate > Standard Calibration...
Pull down Calibrate > Standard Calibration... to create a calibration data set manually.
This leads you through a complete calibration based on the selections that you made in the
Setup menu (for example, calibration instruction set, thru adapter configuration, calibration
preferences, and port selection).
Calibrate > Electronic Calibration...
Pull down Calibrate > Electronic Calibration... to create a calibration data set using the
ECal standard. This leads you through a complete calibration based on the selections that you
made in the Setup menu (for example, calibration instruction set, thru adapter configuration,
calibration preferences, and port selection).
Calibrate > Delete Current Cal
Pull down Calibrate > Delete Current Cal to delete the existing calibration data set.
Chapter 5 135