Agilent Technologies N4413A User Manual page 32

Using the Multiport Test System
How to Set Up the Multiport Test System Hardware
7. Secure the network analyzer's lower locking feet to the test set's upper locking feet by
inserting the shorter two screws between the two pairs of locking feet, one on each side of
the instrument as shown below.
If the screw holes between the network analyzer's lower locking feet are not aligned with
the screw holes in the test set's upper locking feet, loosen the screws securing the feet to
the instruments slightly to align.
8. Tighten all screws.
9. Return to "How to Set Up the Multiport Test System Hardware" on page 18
the installation.
22
to complete
Chapter 3