Removing And Installing Interior Monitoring Sensor G273 And Vehicle Inclination Sender G384; Removing And Installing Interior Monitoring Deactivation Switch E267 And Deactivation Button For Vehicle Inclination Sender E360 - Skoda Octavia III 2013 Workshop Manual

– Unscrew nuts -2- and remove alarm horn with holder -1-.
– Disconnect plug.
Installing
Installation is carried out in the reverse sequence.
6.3 Removing and installing interior moni‐
toring sensor - G273- and vehicle incli‐
nation sender - G384-
Note
The sensors for interior monitoring - G273- and the vehicle incli‐
nation sender - G384- form a building unit and cannot be replaced
separately.
Removing
– Switch off the ignition and all electrical components.
– Remove the interior light in the front roof cover
⇒ "1.1.1 Removing and installing the front interior light", page
144 .
– Release the sensors for interior monitoring -2- out of the bot‐
tom catches and release from the bracket by slightly tilting out
-arrows B-.
– Press off the catches -arrows A- and remove the vehicle incli‐
nation sender -1- with sensors for interior monitoring -2- out of
the interior light.
Installing
Installation is performed in the reverse order, pay attention to the
following points:
– After replacing the sender, you must carry out an online ad‐
justment (parameterisation) with ⇒ Vehicle diagnostic tester.
6.4 Removing and installing interior moni‐
toring deactivation switch -E267- and
deactivation button for vehicle inclina‐
tion sender -E360-
Removing and installing interior monitoring deactivation switch -
E267- and deactivation button for vehicle inclination sender -
E360-
⇒ "2.7 Removing and installing interior monitoring deactivation
switch E 267 and deactivation button for vehicle inclination sender
E 360 ", page 157 .
Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
6. Anti-theft warning system
163