Ignition Key; New Identity When Changing All The Components - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
♦ 01 – Self-diagnosable systems
♦ Immobiliser
♦ Operation
♦ Adjust dash panel insert
8.2

Ignition key

All – even re-ordered – ignition keys are already precoded at the
factory for a specific vehicle and can only be adapted to this ve‐
hicle. When re-ordering ignition keys, the relevant vehicle identi‐
fication number must be provided and subsequently the new keys
must be adapted to the immobiliser control unit - J362-
Note
Before replacing the lock set or the control units, the function
"New identity when changing all the components" must be re‐
trieved.
⇒ "8.2.1 Adapting and checking the ignition key", page 168
8.2.1 Adapting and checking the ignition key
Note
If new or additional ignition keys are required, they must be adap‐
ted to the immobiliser control unit.
Adapt the ignition key to the immobiliser control unit - J362- or
check:
– Connect ⇒ Vehicle diagnostic tester.
– Select the operating mode "Targeted fault-finding" in the ⇒ Ve‐
hicle diagnostic tester.
– Select the "Selected Functions/Components" and subse‐
quently the following menu points using the button "Skip":
♦ Body
♦ Electrical system
♦ 01 – Self-diagnosable systems
♦ Immobiliser
♦ Operation
♦ Adapt and check the ignition key
8.3 New identity when changing all the com‐
ponents
All necessary steps required for the new installation of all the im‐
mobiliser components are carried out with this programme.
– Connect ⇒ Vehicle diagnostic tester.
– Select the operating mode "Targeted fault-finding" in the ⇒ Ve‐
hicle diagnostic tester.
– Select the "Selected Functions/Components" and subse‐
quently the following menu points using the button "Skip":
♦ Body
168
Rep. gr.96 - Lights, bulbs, switches - interior