1 - Connector
❑ Exact contact
assignment⇒ Current
flow diagrams, Electri‐
cal fault finding and Fit‐
ting locations
2 - Data bus diagnostic inter‐
face Gateway - J533-
3 - Screw
❑ 20 Nm
4 - Crash bar
5 - Dash panel central pipe
2.2.2
Remove and install data bus diagnostic
interface Gateway - J533- .
Note
If the data bus diagnostic interface Gateway - J533- is re‐
♦
placed, select the "replace control unit" function of the respec‐
tive control unit in operating mode "Targeted fault finding" or
"Guided Functions" ⇒ Vehicle diagnostic tester.
The assembly work is identical on right-hand drive vehicles.
♦
Removing
– Remove the knee airbag ⇒ Body Work; Rep. gr. 69 .
– Removing the left footwell vent on the driver side ⇒ Heating,
Air Conditioning; Rep. gr. 80 .
Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
179
2. Control units