Removing And Installing Start/Stop Button And Immobiliser Reader Coil For Emergency Start - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
– Remove the noise insulation from the wheelhouse to reach the
aerial -1-.
– Take off aerial -1- from wheelhouse and disconnect plug -2-.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– If the aerial which was taken off is reused, a new double-sided
adhesive tape must be used and the aerial must be fixed again
according to the fig.
10.5.5 Removing and installing the rear aerial
in the middle
Removing
– Switch off the ignition and all electrical components.
– Remove rear bumper ⇒ Body Work; Rep. gr. 63 .
– Press off catch pegs -arrows-, tilt aerial -1- up and push it out.
– Disconnect plug.
Installing
Installation is carried out in the reverse sequence.
10.6 Removing and installing start/stop but‐
ton and immobiliser reader coil for emer‐
gency start
Removing
Note
The steering wheel must not be removed. For installing the fixing
screws of the bottom trim panel for steering column, turn the
steering wheel to the left by 90° and subsequently turn it to the
right.
– First of all remove the top and then the bottom steering column
trim panel ⇒ Body Work; Rep. gr. 70 .
132
Rep. gr.94 - Lights, bulbs, switches - exterior