– Remove the centre console ⇒ Body Work; Rep. gr. 68 .
– Using the disassembly tool (e.g. -MP8-602/1- ) lever the aerial
-1- out of the holder -2- and disconnect the plug connection.
Installing
– Connect plug connection and press the aerial into the holder.
Further installation occurs in reverse order.
10.5.2
Removing and installing aerials and
sensors in the front outer door handles
Not replaceable individually.
In the case of a fault, replace the complete outer door handle ⇒
Body Work; Rep. gr. 57 .
10.5.3
Removing and installing rear left aerial
Removing
– Switch off the ignition and all electrical components.
– Remove left side trim panel in luggage compartment ⇒ Body
Work; Rep. gr. 70 .
– Remove the noise insulation from the wheelhouse to reach the
aerial -2-.
– Take off aerial -2- from wheelhouse and disconnect plug -1-.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– If the aerial which was taken off is reused, a new double-sided
adhesive tape must be used and the aerial must be fixed again
according to the fig.
10.5.4
Removing and installing rear right aerial
Removing
– Switch off the ignition and all electrical components.
– Remove right side trim panel in luggage compartment ⇒ Body
Work; Rep. gr. 70 .
10. Keyless unlocking of the vehicle/the steering, keyless start/stop – KESSY system
Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
131