Access And Start Authorisation Control Unit J965; Aerials Of The Kessy System - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
Other components with which the KESSY system communicates
via the CAN bus
♦ Vehicle voltage control unit - J519-
♦ Data bus diagnostic interface Gateway - J533-
♦ Dash panel insert
♦ Selector lever of the automatic gearbox (vehicles with auto‐
matic gearbox)
♦ Engine control unit
♦ Control unit for ABS/ESC
10.4 Access and start authorisation control
unit - J965-
On vehicles with left-hand and right hand drive, the control unit is
located in the driver side heating and air conditioning unit.
Removing
– Remove dash panel insert
⇒ "1.3 Removing and installing dash panel insert", page 24
– Press off the catch peg -arrow A- and push out the diagnostic
interface -1- from the bracket -2- -arrows B-.
– Disconnect the plug connections -3- by unlocking and tilting
out the clamp.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– If the control unit was replaced, it must be coded with the
⇒ Vehicle diagnostic tester. The ⇒ Vehicle diagnostic tester
must be connected on-line.
– Test the complete system for proper operation.
10.5

Aerials of the KESSY system

⇒ "10.5.1 Removing and installing the aerial under the centre
console", page 130
⇒ "10.5.2 Removing and installing aerials and sensors in the front
outer door handles", page 131
⇒ "10.5.3 Removing and installing rear left aerial", page 131
⇒ "10.5.4 Removing and installing rear right aerial", page 131
⇒ "10.5.5 Removing and installing the rear aerial in the middle",
page 132
10.5.1 Removing and installing the aerial under
the centre console
The aerial is located in the holder in front of the control lever.
Removing
– Switch off the ignition and all electrical components.
130
Rep. gr.94 - Lights, bulbs, switches - exterior
.