Self-Diagnosis Of The Parking Aid - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
11.6.3 Gluing procedure of the sender holders
Note
♦ Park steering assistant sender holders have a countersink
collar. Its visible area -1- must be painted the same colour as
the bumper.
The parking aid sender holder does not have a countersink
♦
collar -1-. Therefore a centring pin must be used for precisely
centring the holder in the bumper or gluing the holder with in‐
serted parking aid sender on which the decoupling ring (black
silicone ring) is placed.
The temperature of the bumper and the sender holder must
♦
be between 15 °C and 30 ℃ during the glueing procedure.
– Clean and thoroughly degrease the marked adhesive area
-1- with isopropyl (technical alcohol).
– Evenly apply activator 3M"Plastprimer 4298UV", or, if neces‐
sary, "Glass/paint primer K 520" in the marked adhesive area
-1-.
– Let the activator dry off for approx. 5 min.
Note
Pay attention to the fitting position
♦
⇒ "11.6.2 Fitting position of the sender holders", page 139
the assignment of the sender holders
⇒ "11.6.1 Assignment of the sender holder", page 139
The application force and the application time determine the
♦
durability of the bonding!
– Remove the protective foils from both sides of the adhesive
tape and press the sender holder -2- into the front bumper for
approx. 10 seconds while applying high force.
11.7

Self-diagnosis of the parking aid

The parking aid system is equipped with self-diagnosis. Carry out
"self-diagnosis" with the ⇒ Vehicle diagnostic tester in the function
"Targeted fault finding".
140
Rep. gr.94 - Lights, bulbs, switches - exterior
and
.