Skoda Octavia III 2013 Workshop Manual page 106

Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
– To access the fixing screw, carefully knock out and remove
the plug -arrow-.
– To be able to see the headlight range control motor better,
remove the Control unit for daylight driving light and side light
- J860- (LED module -1-
⇒ "2.11 Removing and installing Control unit for daylight driv‐
ing light and side light J860 (LED module) left and J861 right",
page 95 .
– Remove the gas discharge lamp
⇒ "2.5.4 Replacing the gas discharge lamp ", page 93
– Unscrew fixing screws -1-.
– Unhook the control of the control motor out of the bearing
-arrow-.
– Take out the control motor -2- taking connected wiring lengths
into consideration and disconnect the connector.
Install
Installation is performed in the reverse order, pay attention to the
following points:
– The knocked-out plug -arrow- must be replaced by a new plug,
see ⇒ Electronic Catalogue of Original Parts .
– After installing the control motor, check the function is correct.
98
Rep. gr.94 - Lights, bulbs, switches - exterior
.