– Tighten new screws -arrows- until the screw heads have been
broken off.
9.3
Removing and installing the ELV - J764-
Note
If the control unit is replaced, select the "replace control unit"
function of the respective control unit⇒ Vehicle diagnostic tester.
Removing
– Remove steering wheel ⇒ Body Work; Rep. gr. 69 , bottom
and top steering column trim panel ⇒ Body Work; Rep. gr.
70 .
– Remove the switch unit on the steering column
⇒ "8.3 Removing and installing switch unit on the steering col‐
umn", page 119
.
– Unlock and disconnect plug connection -1-.
– Drill off screws -arrows- with angle drill with a drill bit of ∅ 8.5
mm.
– Remove control unit -2-.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Tighten new screws -arrows- until the screw heads have been
broken off.
Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
9. Steering lock with ignition starter switch and lock cylinder
125