Removing And Installing Steering Lock Housing - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
– Lead steel cable -2- (about 1.2 mm in diameter) through the
hole in the ignition key -arrow-.
– This unlocks the fuse -3- and the lock cylinder -1- can be pulled
out of the steering lock.
– When pulling out the lock cylinder, carefully loosen the immo‐
biliser reader coil cable.
– Separate plug connection for immobiliser -1-.
Note
The reading coil for the vehicle immobiliser is fixed to the lock
cylinder and cannot be replaced separately.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Place the ignition key in the lock cylinder and turn to position
"Ignition on".
– Put unlocking wire -2- into the front drilled hole -arrow-.
– Push lock cylinder with reader coil into the steering lock hous‐
ing.
– Pull out the wire and lock cylinder until there is an audible click.
– Fit the plug connection together on the reading coil.
Note
Pay attention to the correct position of the cable to the reading
coil of the vehicle immobiliser when inserting the lock cylinder.
9.2 Removing and installing steering lock
housing
Removing
– Remove steering wheel ⇒ Body Work; Rep. gr. 69 , bottom
and top steering column trim panel ⇒ Body Work; Rep. gr.
70 .
– Remove the switch unit on the steering column
⇒ "8.3 Removing and installing switch unit on the steering col‐
umn", page 119 .
– Disconnect plug connections -1- and -3-.
– Drill off screws -arrows- with angle drill with a drill bit of ∅ 8.5
mm.
– Remove steering lock housing -2- with ignition/starter switch
and lock cylinder.
– Remove lock cylinder
⇒ "9.1 Removing and installing lock cylinder", page 123
ignition/starter switch if necessary
⇒ "9.4 Removing and installing ignition/starter switch",
page 126 .
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
124
Rep. gr.94 - Lights, bulbs, switches - exterior
and