Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
– Screw out the screw -2- (1.1 Nm) and push the switch unit
-1- out of the bracket on the steering lock.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Before pushing the switch unit onto the steering column the
correct installation position of the ring rotor must be checked:
•
The arrows -1- must be facing each other
•
The coil spring -2- must be visible in the window between the
arrows -4-
Set the correct position if necessary
⇒ "8.5 Setting the correct installation position of the restoring ring
with coil spring", page 121
– Make sure that all the retaining lugs and plug connections lock
in place correctly.
8.4
Removing and installing steering col‐
umn electronics control unit - J527-
Note
The airbag coil spring and restoring ring with slip ring - F138-
♦
are integrated into the steering column electronics unit -
J527- .
If the control unit is replaced, select the "replace control unit"
♦
function of the respective control unit⇒ Vehicle diagnostic test‐
er.
Removing
– Remove steering wheel ⇒ Body Work; Rep. gr. 69 . Before
the steering wheel is removed from the steering column, the
wheels must be in the straight ahead position.
– Removing top and bottom steering column trim ⇒ Body Work;
Rep. gr. 70 .
120
Rep. gr.94 - Lights, bulbs, switches - exterior
.