Adjusting Fog Lights; Replacing Bulb For The Fog Light - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
– Unclip the cover -1- over the fog light.
– Screw out the screws -arrows- (1.5 Nm) and remove the fog
light -2-.
– Disconnect plug.
Install
Installation is carried out in the reverse order.
5.3

Adjusting fog lights

Note
Use a headlight beam setting device for setting the headlight
beam. The nominal values and the adjustment procedure can be
found in the Manual ⇒ Maintenance ; Booklet Octavia III .
5.4

Replacing bulb for the fog light

WARNING
H8 and H16 bulbs are pressurised and can burst when chang‐
ing the bulb - risk of injury! Wear gloves and safety spectacles
when changing the lamps.
Note
Do not touch the glass when installing the light bulb. Your fingers
will leave traces of grease on the glass which then evaporate
when the bulb is switched on causing it to cloud.
– Switch off the ignition and all electrical components.
All vehicles except for Octavia RS:
– Remove the fog light with the defective light bulb
⇒ "5.2 Removing and installing fog light", page 107
Octavia RS:
– Remove headlight left - front bumper ⇒ Body Work; Rep. gr.
63 .
– Right headlight- remove the front right wheelhouse liner ⇒
Body Work; Rep. gr. 66 .
108
Rep. gr.94 - Lights, bulbs, switches - exterior
.