Skoda Octavia III 2013 Workshop Manual page 163

– Slacken the control element out of the catch pegs -arrows- and
remove.
Installation is carried out in the reverse sequence.
2.5.2 Switch on passenger side and rear
Removing
– Remove top cover of the tightening handle -1- -arrow-.
– Unclip switch -1- -arrows- and take it out of the cover -2-.
– Release and pull off connector -1-.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Note
While pressing the switch in, hold the trim panel -2- in which the
switch is located firmly from above.
– Press the switch into the trim panel until the catches click au‐
dibly.
Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
2. Interior switches, in the dash panel, the centre console and the doors
155