– Turn socket with bulb -1- -arrow- and remove.
– Replace defective light bulb.
– Installation is carried out in the reverse sequence.
2.5.3
Replacing bulb PYW24Y for the turn sig‐
nal light
The work sequence is the same as when changing the halogen
headlight
⇒ "1.4.3 Replacing bulb PYW24Y for the turn signal light",
page 82
.
2.5.4
Replacing the gas discharge lamp
WARNING
Mortal high voltage, risk of injury and risk of pollution.
Observe the use and safety instructions for the gas discharge
lamps in the Workshop Manual "Electrical System - general
notes" ⇒ Electrical System - general notes; Rep. gr. 94 .
Note
♦
Do not touch the glass bulb when installing. Your fingers will
leave traces of grease on the glass bulb, which then evaporate
when the gas discharge lamp is switched on causing the glass
bulb to cloud.
Pay attention to the correct fitting and undamaged seals on
♦
the plastic covers as well as the correct positioning of the cov‐
er. Water ingress will destroy the headlight.
Removing
– Switch off the ignition and all electrical components.
– Unplug the connector from the headlight.
– Remove cover -1-.
Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
2. Headlights – Bi-xenon headlights
93