1-Port Serial Mini-Physical Interface Module Leds; 1-Port Serial Mini-Physical Interface Module Supported Standards; Table 36: 1-Port Serial Mini-Pim Led States - Juniper SRX Series Manual

1-Port Serial Mini-Physical Interface Module LEDs

Related
Documentation

1-Port Serial Mini-Physical Interface Module Supported Standards

Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
The 1-Port Serial Mini-Physical Interface Module (Mini-PIM) has one LED located to the
right of the serial port. Table 36 on page 63

Table 36: 1-Port Serial Mini-PIM LED States

Name Color
STATUS Green
1-Port Serial Mini-Physical Interface Module Overview on page 61
1-Port Serial Mini-Physical Interface Module Hardware Specifications on page 62
1-Port Serial Mini-Physical Interface Module Supported Standards on page 63
1-Port Serial Mini-Physical Interface Module Key Features on page 62
1-Port Serial Mini-Physical Interface Module Basic Configuration on page 214
The 1-Port Serial Mini-Physical Interface Module (Mini-PIM) supports the following
standards:
TIA/EIA 530
V.35
X.21
RS-232
RS-449
1-Port Serial Mini-Physical Interface Module Overview on page 61
1-Port Serial Mini-Physical Interface Module Hardware Specifications on page 62
1-Port Serial Mini-Physical Interface Module Key Features on page 62
1-Port Serial Mini-Physical Interface Module LEDs on page 63
1-Port Serial Mini-Physical Interface Module Basic Configuration on page 214
Chapter 8: 1-Port Serial Mini-Physical Interface Module
describes the LED states.
State Description
On Online with no alarms or failures.
Off Device has detected a failure.
63