Figure 2: Srx650 Services Gateway Slot Numbers; Figure 3: Example Of A Standard Gpim (Installs In One Standard Slot); Figure 4: Example Of A Double-High, Single-Wide Xpim; Figure 5: Example Of A Double-High, Double-Wide Xpim - Juniper SRX Series Manual

SRX Series Services Gateways for the Branch Physical Interface Modules Reference
Related
Documentation
10

Figure 2: SRX650 Services Gateway Slot Numbers

650
NOTE: Only the SRX650 Services Gateway supports hot-swappable
functionality for GPIMs. Because the services gateway GPIMs communicate
with the backplane at various performance levels, you must install them in
the correct slots.
Figure 3 on page 10, Figure 4 on page
factors for the services gateway GPIMs.

Figure 3: Example of a Standard GPIM (Installs in One Standard Slot)

Figure 4: Example of a Double-High, Single-Wide XPIM

Figure 5: Example of a Double-High, Double-Wide XPIM

Required Tools and Parts for Replacing a Gigabit-Backplane Physical Interface Module
on page 245
Removing a Blank Gigabit-Backplane Physical Interface Module Faceplate from the
SRX Series Services Gateway on page 255
Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services
Gateway on page 256
Installing a Double-High, Double-Wide Gigabit-Backplane Physical Interface Module
on the SRX Series Services Gateway on page 258
7
5
3
1
10, and Figure 5 on page 10
Copyright © 2015, Juniper Networks, Inc.
8
6
4
2
show the three form