8-Port Serial Gpim Key Features; 8-Port Serial Gpim Hardware Specifications - Juniper SRX Series Manual

8-Port Serial GPIM Key Features

Related
Documentation

8-Port Serial GPIM Hardware Specifications

Copyright © 2015, Juniper Networks, Inc.
8-Port Serial GPIM Basic Configuration on page 230
The 8-Port Serial Gigabit-Backplane Physical Interface Module (GPIM) provides the
following key features:
Autoselection of operational modes based on data terminal equipment (DTE) or data
circuit-terminating equipment (DCE) cables
Local, remote, and dce-local loopback diagnostics
Clock rate from 1.2 KHz to 8 MHz
Clocking mode—DCE clock, Internal (Baud) clock, and External (loop) clock
Complete configuration and management using the CLI
Maximum transmission unit (MTU) values of 1504 bytes (default) and 9192 bytes
(maximum)
Line encoding for NRZ and NRZI modes
Support for Frame Relay, PPP (PAP/CHAP), Cisco-HDLC, MLFR, and MLPPP (with the
maximum throughput at 44 Mbps for 64-byte packet).
Support for data signal and control signal alarms
Support for invert data
Support for Serial auto-resync
Support for loopback modes (local and remote) and for ignoring control signals
Support for receiving SNMP information at each port
8-Port Serial GPIM Overview on page 97
8-Port Serial GPIM Hardware Specifications on page 99
8-Port Serial GPIM Components on page 98
8-Port Serial GPIM LEDs on page 100
8-Port Serial GPIM Interface Cables on page 161
8-Port Serial GPIM Interface Specifications on page 26
8-Port Serial GPIM Basic Configuration on page 230
Table 54 on page 100 lists the hardware specifications of the 8-Port Serial
Gigabit-Backplane Physical Interface Module (GPIM).
Chapter 14: 8-Port Serial GPIM
99