Table of Contents
Advertisement
SRX Series Services Gateways for the Branch Physical Interface Modules Reference
Related
Documentation
8-Port Gigabit Ethernet SFP XPIM Components
Related
Documentation
92
8-Port Gigabit Ethernet SFP XPIM Hardware Specifications on page 93
8-Port Gigabit Ethernet SFP XPIM Network Interface Specifications on page 25
8-Port Gigabit Ethernet SFP XPIM Supported Modules on page 95
8-Port Gigabit Ethernet SFP XPIM Key Features on page 93
8-Port Gigabit Ethernet SFP XPIM LEDs on page 94
8-Port Gigabit Ethernet SFP XPIM Components on page 92
8-Port Gigabit Ethernet SFP XPIM Basic Configuration on page 227
The 8-Port Gigabit Ethernet small form-factor pluggable Gigabit-Backplane Physical
Interface Module (SFP XPIM) contains the components listed in
Table 49: 8-Port Gigabit Ethernet SFP XPIM Components
Component
ONLINE/OFFLINE button
TX and RX coaxial
connectors
Two captive screws
8-Port Gigabit Ethernet SFP XPIM Overview on page 91
8-Port Gigabit Ethernet SFP XPIM Hardware Specifications on page 93
8-Port Gigabit Ethernet SFP XPIM Network Interface Specifications on page 25
8-Port Gigabit Ethernet SFP XPIM Supported Modules on page 95
8-Port Gigabit Ethernet SFP XPIM Key Features on page 93
8-Port Gigabit Ethernet SFP XPIM LEDs on page 94
8-Port Gigabit Ethernet SFP XPIM Basic Configuration on page 227
Location
Description
Right side of the XPIM
Use the ONLINE/OFFLINE button to
gracefully shut down the XPIM. Press down
and hold the button for 4 to 5 seconds;
then release. The XPIM gracefully shuts
down and turns off the power supply units
(PSUs).
To power up the XPIM (if the Services and
Routing Engine [SRE] is off), press and
hold the ONLINE/OFFLINE button for 4 to
5 seconds.
Middle/right of the
Dual female 75-ohm BNC coaxial
XPIM
connectors: TX (transmit) and RX
(receive).
One on each side of
Use the captive screws to hold the XPIM
the XPIM
in place.
Table 49 on page
Copyright © 2015, Juniper Networks, Inc.
92.
Hide quick links:
Advertisement
Chapters
Table of Contents
