16-Port Gigabit Ethernet Xpim Key Features - Juniper SRX Series Manual

Related
Documentation

16-Port Gigabit Ethernet XPIM Key Features

Copyright © 2015, Juniper Networks, Inc.
Table 56: 16-Port Gigabit Ethernet XPIM Components (continued)
Component
16 fixed Gigabit Ethernet ports
labeled 0 to 15
NOTE: The 16-Port Gigabit
Ethernet with PoE XPIM port
labels are yellow instead of
white.
Captive screws
Handles
16-Port Gigabit Ethernet XPIM Overview on page 103
16-Port Gigabit Ethernet XPIM Key Features on page 105
16-Port Gigabit Ethernet XPIM Hardware Specifications on page 106
16-Port Gigabit Ethernet XPIM LEDs on page 106
16-Port Gigabit Ethernet XPIM Basic Configuration
Power over Ethernet Support on SRX Series Services Gateway Interfaces on page 16
The 16-Port Gigabit Ethernet XPIM has the following key features:
16 triple-speed (10/100/1000 Mbps) Ethernet ports, double-high card
PoE support for all ports
PCI-Express interface for control and management
I2C interface for module monitor and identification
Maximum module power of 40.0 W without PoE
JTAG support for boundary scan test
Chapter 15: 16-Port Gigabit Ethernet XPIM
Location
Middle of the XPIM
One on each side of the XPIM
One on each side of the XPIM
Description
NOTE: Each port on the
16-Port Gigabit Ethernet with
PoE XPIM supports Power over
Ethernet (PoE).
Each Gigabit Ethernet port:
Provides link speeds of
10/100/1000 Mbps
Uses an RJ-45 connector
Operates in full-duplex and
half-duplex modes
Supports flow control
Supports autonegotiation
Use the captive screws to hold
the XPIM in place in the
services gateway.
Use the handles to grasp the
XPIM for installation or
removal.
105