T1/E1 Mini-Physical Interface Module; Connector To Rj-48 Connector (Straight) Pinouts For The 1-Port; Mini-Physical Interface Module; Table 70: Rj-48 Connector To Rj-48 Connector (Straight) Pinouts - Juniper SRX Series Manual

CHAPTER 19

T1/E1 Mini-Physical Interface Module

RJ-48 Connector to RJ-48 Connector (Straight) Pinouts for the 1-Port T1/E1

Mini-Physical Interface Module

Copyright © 2015, Juniper Networks, Inc.
RJ-48 Connector to RJ-48 Connector (Straight) Pinouts for the 1-Port T1/E1
Mini-Physical Interface Module on page 127
RJ-48 Connector to RJ-48 Connector (Crossover) Pinouts for the 1-Port T1/E1
Mini-Physical Interface Module on page 128
RJ-48 Connector to DB-15 Connector (Straight) Pinouts for the 1-Port T1/E1
Mini-Physical Interface Module on page 129
RJ-48 Connector to DB-15 Connector (Crossover) Pinouts for the 1-Port T1/E1
Mini-Physical Interface Module on page 130
The 1-Port T1/E1 Mini-Physical Interface Module (Mini-PIM) uses an RJ-48 cable, which
is not supplied with the Mini-PIM.
CAUTION: To maintain agency approvals, use only a properly constructed,
shielded cable.
Table 70 on page 127 gives RJ-48 connector to RJ-48 connector (straight) pinouts.

Table 70: RJ-48 Connector to RJ-48 Connector (Straight) Pinouts

RJ-48 Pin (on 1-Port RJ-48 Pin (Data
T1/E1 Mini-PIM) Numbering Form)
1 1
2 2
4 4
5 5
3 3
6 6
Signal
RX, Ring, –
RX, Tip, +
TX, Ring, –
TX, Tip, +
Shield/Return/Ground
Shield/Return/Ground
127