1-Port Serial Mini-Physical Interface Module; 1-Port Serial Mini-Physical Interface Module Overview; Figure 13: 1-Port Serial Mini-Pim Front Panel - Juniper SRX Series Manual

CHAPTER 8
1-Port Serial Mini-Physical Interface
Module

1-Port Serial Mini-Physical Interface Module Overview

Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
1-Port Serial Mini-Physical Interface Module Overview on page 61
1-Port Serial Mini-Physical Interface Module Key Features on page 62
1-Port Serial Mini-Physical Interface Module Hardware Specifications on page 62
1-Port Serial Mini-Physical Interface Module LEDs on page 63
1-Port Serial Mini-Physical Interface Module Supported Standards on page 63
Serial WAN links are bidirectional links and require very few control signals. In a basic
serial setup, the data circuit-terminating equipment (DCE) is responsible for establishing,
maintaining, and terminating a connection. A modem is a typical DCE device. A serial
cable connects the DCE to a telephony network where, ultimately, a link is established
with data terminal equipment (DTE). DTE is typically where a link terminates.
Figure 13 on page 61 shows the front panel of the 1-Port Serial Mini-Physical Interface
Module (Mini-PIM).

Figure 13: 1-Port Serial Mini-PIM Front Panel

1-Port Serial Mini-Physical Interface Module Hardware Specifications on page 62
1-Port Serial Mini-Physical Interface Module Supported Standards on page 63
1-Port Serial Mini-Physical Interface Module Key Features on page 62
1-Port Serial Mini-Physical Interface Module LEDs on page 63
1-Port Serial Mini-Physical Interface Module Basic Configuration on page 214
61